RADTEC RAD-XR-10012 Aluminium Floating Servo Mount for Xray T4-15  [RAD-XR-10012]

RAD-XR-10012 Aluminum Floating Servo Mount for Xray T4-15
Price:
NZD$29.46
Brand:
RADTEC
Model:
RAD-XR-10012
Condition:
Brand New
Write a review

Refine Servo Performance on the Xray T4-15

The RADTEC Aluminium Floating Servo Mount crafted for the Xray T4-15 helps riders achieve steadier steering by separating the servo from chassis flex. It gives the servo a cleaner platform so steering reactions are more repeatable lap after lap.

What the Floating Concept Delivers

Floating mounting reduces direct loads transferred from the chassis to the servo, lowering the chance of binding or misalignment under hard cornering. That means more consistent centring and better feel through turns.

Installation Tips and Compatibility

Specifically matched to the Xray T4-15 the mount fits with standard hardware and a simple installation. The alloy construction is durable yet lightweight to avoid upsetting the car's balance.

Can I run this with a standard hobby servo or do I need a high torque unit?

It works with most standard digital and analogue servos, though higher torque digital servos will benefit from the more stable mounting when driving hard.

Does the mount need shims or spacers during setup?

Some setups use thin shims to fine tune horn alignment; check for parallel linkage and minimal binding after fitting.

Will the aluminium corrode if I run in wet conditions?

The alloy is fairly corrosion resistant but rinse and dry components after exposure to moisture and inspect fasteners for signs of rust.

Any advice for tuning after installation?

Recheck steering end points and centring, then test at low speed before a full session to confirm there is no binding and that steering response is linear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved