RADTEC RAD-XR-10017 Aluminium Split Mount for T4-2014 CR  [RAD-XR-10017]

Price:
NZD$26.00
Brand:
RADTEC
Model:
RAD-XR-10017
Condition:
Brand New
Write a review

Refine handling with RADTEC RAD-XR-10017

The RADTEC Aluminum Split Suspension Mount, model RAD-XR-10017, suits XRAY T4-2014 and CR chassis and gives accurate setup control. The +/-0.25-degree adjustment helps you dial in small changes to toe and caster.

Stability through precise geometry

Made with the older XRAY T series in mind, this aluminium mount increases structural stability under cornering forces. The split construction allows riders to alter suspension geometry in small steps for more consistent lap times.

Compatibility and easy swap

Designed for XRAY T4-2014 and CR models, the mount fits without complex modification and is installed with routine workshop tools. Its direct replacement style keeps the upgrade simple.

Will this mount change ride height or geometry a lot?

The mount is intended to preserve original geometry while enabling fine adjustment; major ride height changes are not expected without other setup edits.

Is any modification required for my T4-2014?

No special modifications are normally needed. The RADTEC RAD-XR-10017 is made to fit the specified XRAY models as a direct upgrade.

What maintenance should I do after fitting?

Check fasteners for correct torque after initial runs and recheck alignment after a few sessions to confirm the settings.

Can I combine this with other aluminium upgrades?

Yes, pairing with other aluminium components can give a more rigid chassis response, but tune gradually to find the right balance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved