RADTEC RAD-XR-10025 Hard Coated Aluminium Diff Cup Upgrade for Xray T4-15/16  [RAD-XR-10025]

RAD-XR-10025 Hard Coated Aluminum Gear Differential Cup for Xray T4-15/16
Price:
NZD$26.00
Brand:
RADTEC
Model:
RAD-XR-10025
Condition:
Brand New
Write a review

Improve Durability on Your Xray T4

The RADTEC RAD-XR-10025 hard coated aluminium gear differential cup is produced for Xray T4-15/16 models. Built from solid aluminium with a protective hard finish, it boosts longevity for club racers and weekend builders alike.

Designed for Fit and Strength

This diff cup is dimensioned to sit correctly in the Xray T4-15/16 chassis, offering a reliable combination of toughness and controlled mass. The hard coat reduces surface wear during heavy use.

Simple Replacement Procedure

Installing the RAD-XR-10025 is a quick job for most hobbyists, allowing you to swap out worn parts and get back on track. Its compatibility with earlier T variants adds flexibility for older cars.

Can I use this on other Xray models?

The cup is tailored to Xray T4-15/16 geometry. It may fit other Xray cars with modification, but check measurements before assuming compatibility.

How does the hard coat affect wear?

The hard coating provides a tougher running surface that slows down abrasive wear, which is helpful in high-stress driving like competitive heats.

Is any setup change needed after install?

Most cars will run the same geometry after swapping to this cup. Verify mesh and diff preload during reassembly to ensure optimum performance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved