RADTEC RAD-XR-10028 T4-16 7075 2.0mm Performance Chassis  [RAD-XR-10028]

RAD-XR-10028 T4-16 7075 Aluminum Main Chassis, 2.0mm
Price:
NZD$111.79
Brand:
RADTEC
Model:
RAD-XR-10028
Condition:
Brand New
Write a review

Tune your XRAY T4-16 with a stiffer main chassis

If you want crisper responses from your XRAY T4-16, the RADTEC 2.0mm 7075 aluminium main chassis is a practical upgrade. Built from durable 7075 alloy, this chassis plate reduces flex and helps maintain consistent handling over long runs.

What the 2.0mm thickness delivers

The 2.0mm plate gives a solid mix of stiffness and weight control, helping the car resist mid-corner deformation. The result is steadier corner exits and more predictable behaviour under load.

Direct fitment and quick swap

This chassis is shaped for the XRAY T4-16 mounting pattern so it installs without cutting or drilling. The straightforward swap uses your existing screws and leaves setup options intact.

Can I use this on a different XRAY car?

This part is intended for the XRAY T4-16. Other XRAY cars may not share the same holes or geometry and could require modifications to fit.

Does the RADTEC RAD-XR-10028 add much weight?

A 2.0mm 7075 plate balances stiffness and mass; it may be slightly heavier than very thin carbon plates but gives improved rigidity and handling consistency.

How should I care for a 7075 chassis?

Keep the chassis clean of grit, regularly check mounting screws for tightness, and inspect for nicks. Promptly replace or repair any damaged plates to retain predictable handling.

Will I need new hardware to fit it?

The chassis is made to use standard T4-16 hardware. Verify screw lengths before final assembly and reuse your existing hardware where suitable.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved