RADTEC RAD-XR-20033 Precision Camber Bushings for XRAY X1 1 Dot 1.5/2.5 Degrees 2pc  [RAD-XR-20033]

RAD-XR-20033 Aluminum Camber Bushing for X1, 1 Dot, 1.5/2.5 deg, 2 pcs
Price:
NZD$13.00
Brand:
RADTEC
Model:
RAD-XR-20033
Condition:
Brand New
Write a review

RADTEC RAD-XR-20033 Camber Bushings for Precision Tuning

The RADTEC RAD-XR-20033 camber bushings are designed for the XRAY X1 and come in 1.5 and 2.5 degree choices to help you refine handling. These small but effective parts let you dial camber in a controlled way for different track surfaces.

Simple Dot Orientation

A single dot marks the bushing for easy orientation during assembly, so you can install and identify settings quickly between practice runs. The two angle choices provide straightforward tuning steps to adapt grip and turn-in balance.

Machined Aluminium Build

Made from quality aluminium, the bushings resist deformation and deliver consistent contact geometry under load. Their construction supports reliable adjustments and reduced setup variation over time.

Are RADTEC RAD-XR-20033 bushings interchangeable between front and rear?

You can use them in either position as long as the suspension geometry and spacing match; check clearance and orientation during fitment.

Which angle works best on carpet or low-grip surfaces?

Lower camber (1.5 degrees) often helps on tight or low-grip tracks to keep more tyre contact during steering; testing is recommended to confirm.

How do I check wear on these bushings?

Inspect for ovaling or looseness in the bore and verify alignment after heavy running; replace if you see deformation to maintain precise camber.

Can I reuse the bushings when changing setups?

Yes, aluminium bushings can be reused while in good condition, but track testing will show if fresh parts are needed for consistent results.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved