RAD-YK-10018 RADTEC BD8-2017 Aluminium C-Hub 0deg  [RAD-YK-10018]

RAD-YK-10018 BD8-2017 Aluminum C-Hub for RTC, 0 Deg
Price:
NZD$52.00
Brand:
RADTEC
Model:
RAD-YK-10018
Condition:
Brand New
Write a review

Fine-Tune Your BD8-2017 Setup

The RADTEC RAD-YK-10018 aluminium C-Hub is a straightforward upgrade for Yokomo BD8-2017 owners seeking improved steering consistency. Its 0 degree orientation helps retain neutral camber for stable corner exits.

Built to Last and Perform

Constructed from quality aluminium, this C-Hub resists the flex and wear seen with plastic components. That durability keeps steering geometry reliable lap after lap, which is useful for club racing and practice sessions.

Fitment and Quick Install

This C-Hub is made to slot into the BD8-2017 without chassis alterations, using the vehicle's original mounting points and bolts for a clean, fast swap.

Can I use this hub with aftermarket uprights?

In most cases yes, but check the upright geometry and hole spacing to ensure the RAD-YK-10018 lines up correctly with any aftermarket parts.

Does the 0deg hub affect camber gain during suspension travel?

The 0 degree hub maintains neutral static camber; dynamic camber gain from suspension movement will remain governed by your arm angles and shock tuning.

Are spacers or shims needed for installation?

No special spacers are normally required. Use the original hardware and check for free movement after assembly, adding thin shims only if fitment needs minor adjustment.

How will this part change on-track feedback?

Expect a firmer, more direct steering feel and less play under load, which can help with precise steering corrections and confidence through fast turns.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved