RBX10 RYFT Aftermarket 7075 25T Servo Horn RBX025TSH by GPM  [RBX025TSH]

25T 7075 aluminium servo horn suited to RBX10 RYFT

This aftermarket 25T servo horn is manufactured from 7075 T6 aluminium for a balance of stiffness and low mass, aimed at scale steering setups that need a tougher arm. The straight-arm design gives solid feedback while an internal spring helps damp impact forces that can travel back into the servo.

The horn features two tie-rod positions so you can alter the steering throw and response without changing servo end point settings. It is specifically for 25T splines and will not mate with 23T servos.

Fitting is simple: remove the original horn, engage the 25T spline, fasten with the supplied screws, and adjust the tie-rod to the desired hole to tune steering sensitivity. This part is intended as an aftermarket steering tune and to reduce shock loads on the servo via the spring.

Best used when you need an aluminium horn that softens impacts and lets you quickly tweak steering leverage; double-check servo spline type before installing.