RC18T Battery Plate Graphite Upgrade RC18-021A by 3Racing  [RC18-021A]

Team Associated RC18T Graphite Battery Plate - 3RACING RC18-021A
Price:
NZD$12.00
Brand:
3Racing
Model:
RC18-021A
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Graphite Battery Plate for RC18T

This graphite battery plate serves as a drop-in replacement for the Team Associated RC18T battery bay. Produced as an aftermarket hop-up, it offers a lighter, stiffer surface for mounting the pack in the RC18T layout.

Installation uses the RC18T's existing screw points and original hardware. When fitting, align the plate carefully, check that battery straps or mounts line up, and confirm there is enough room around the ESC and wiring harness to avoid rubbing.

Graphite raises local stiffness compared to stock plastic plates, which can alter how flex is distributed through the chassis and affect handling. Introduce this upgrade while making small setup changes and monitor handling on brief runs to evaluate front to rear balance.

Is the plate a direct fit on RC18T?

Yes, it is made to match the RC18T battery area, but always dry-fit and check screw alignment before final assembly.

Will it change how I secure the battery?

The mounting method remains the same using the chassis points; however verify strap routing and holder seating to ensure a snug, rattle-free fit.

Maintenance tips for graphite plates?

Keep the plate clean from grit, check fastener torque after a few runs, and look for any signs of edge damage that could affect pack security.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved