RC18T/RC18R Rear Toe-Out Mount 0 Degree Aluminium RC18-016/SI by 3Racing  [RC18-016/SI]

Fixed 0 degree rear toe mount for RC18 platforms

This aluminium rear toe-out mount is an aftermarket replacement compatible with Team Associated RC18T and RC18R chassis, designed to give a consistent 0 degree toe reference for the rear wheel hub. It suits 1/18 scale race setups where repeatability matters.

The piece uses the RC18T/RC18R rear mounting pattern and provides a tougher mounting surface than standard plastic parts, reducing unwanted deflection and helping maintain toe under corner loads.

Installation is direct on the original hub mounting points using the existing hardware. Apply moderate torque to avoid stripping threads and check wheel alignment after first runs since the mount establishes fixed geometry rather than adjustable settings.

Mechanics often fit this mount when verifying baseline suspension geometry or when they need a stable 0 degree rear toe during setup iterations; regular checks for looseness or burrs after sessions will keep handling predictable.