This item is an aluminium replacement for the rear suspension arms fitted to Blitzer Beetle, Stadium Blitzer and Stadium Thunder models. The components feature a light blue anodised surface and are intended as direct hop-up replacements for the rear arm assemblies named above.
Fitment is restricted to those models: Blitzer Beetle, Stadium Blitzer and Stadium Thunder. These alloy arms are used where the stock plastic arms are removed for maintenance or when a stiffer, longer-lasting component is required for chassis tuning.
Fitting follows the same rear mounting points as the originals, so no chassis geometry changes are necessary. Remove the existing rear arms, migrate any needed bushings or small parts from the originals, then install the aluminium arms at the standard mounting locations. Confirm that the suspension moves freely through its travel after installation.
As a tuning element the aluminium arms are straightforward: compared with plastic they offer improved rigidity and reduced wear, which can stabilise alignment under load. Use them together with progressive adjustments to springs, dampers and toe to fine-tune handling.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved