Rear Spring 13mm RR 2lbs - Serpent 500913  [SER500913]

Price:
NZD$0.00
Brand:
Serpent
Model:
SER500913
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Product Brief: Rear Spring

This 13mm rear shock spring from Serpent is supplied in red and carries a 2lbs stiffness rating. It is supplied as a replacement spring intended for rear shock assemblies and for fine tuning rear suspension response.

To fit, place the spring over the shock shaft or into the spring retainer after removing the top cap per your shock's instructions, then rebuild and check travel and preload before use.

For reliable results, match the spring choice with compatible shock oil and the correct preload setting so lap-to-lap behaviour stays consistent. This item is an RC component for model vehicles and setup testing.

What is the correct method to install this rear spring?

Remove the shock cap and shaft as per the shock manual, slide the spring onto the shaft or into the retainer, then reassemble, adjusting preload and ensuring full travel without binding.

Does the red finish affect performance or fit?

The colour is cosmetic only; it does not change stiffness or fit. Verify physical dimensions to ensure correct seating on your shock retainer.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved