Rear Suspension Arm for HPI Bullet 3.0 MT/ST - Orange Alloy - BUL-18010-OR by Jazrider  [BUL-18010-OR]

HPI Bullet - Orange Alloy Rear Suspension Arm
Price:
NZD$24.68
Brand:
JAZRIDER
Model:
BUL-18010-OR
Condition:
Brand New
Available in shop
Write a review

Overview of the Rear Suspension Arm

This orange alloy rear suspension arm is designed as an RC replacement specifically for HPI Bullet models. It replaces the factory plastic arm with a stronger alloy option intended to resist breakage during hard use.

The component lists compatibility with Bullet 3.0 MT and ST (Nitro Engines); confirm mount spacing and pivot clearances on your chassis before final installation. Typical removal of the rear wheel, hub disassembly, and reattachment of linkage using original hardware is required.

As a fixed replacement the arm preserves the original rear suspension geometry so you can return the chassis to its intended alignment after damage. Follow normal tool and safety practices when servicing fuel-powered RCs.

How much tougher is the alloy arm compared with stock plastic?

The alloy construction offers greater impact resistance than standard plastic arms, reducing the chance of breakage in many crash scenarios; however, severe impacts can still deform metal parts.

Will the orange finish hold up outdoors?

The coloured alloy is primarily cosmetic; normal wear from use and exposure can occur. Inspect mounting areas regularly and replace if excessive wear appears.

Can I use this arm with other Bullet-series modifications?

It works as a direct replacement within the stock geometry; compatibility with aftermarket uprights or extended links should be checked on a case-by-case basis.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved