Rear Suspension Holder for LAZER ZX (Gunmetal, LAW95GM) Kyosho  [KY-LAW95GM]

Kyosho LAW95GM - Al Rear Sus. Holder (RR/Gunmetal/LAZER)
Price:
NZD$0.00
Brand:
Kyosho
Model:
KY-LAW95GM
GTIN:
4548565525676
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Kyosho - LAZER ZX series category
Write a review

LAZER ZX Rear Mounting Alloy

This aluminium rear suspension holder is a replacement chassis component for the LAZER ZX series and carries the LAW95GM identifier. The gunmetal anodized coating helps resist wear and keeps link and hub mating surfaces consistent.

As a direct mount part, it secures rear linkages and sets the mounting geometry rather than altering suspension architecture. Swapping in an alloy holder reduces local flex compared with plastic originals, offering a firmer platform for rear toe and roll centre adjustments.

Installation guidance: where possible reuse original mounting fasteners, confirm alignment before final torque, avoid excessive tightening, clear threaded holes of grit, and verify link geometry after fitment. This component is intended for 1/10 scale RC use on compatible LAZER ZX chassis only.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How tough is the gunmetal anodized finish?

The anodize improves surface wear resistance and reduces corrosion risk, but severe impacts can still mar the finish. Clean grit away before storage and inspect after any heavy contact.

Will the alloy reduce long term wear on link interfaces?

Because the aluminium part reduces local deflection, it can limit movement-related wear at link and hub contact points, though bearings and fasteners still need routine inspection.

Can I restore minor scratches on the finish?

Minor scuffs may be protected with light corrosion inhibitors, but deep gouges will not be fully restored and may require part replacement if structural integrity is affected.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved