Receiver Wiring Junction Compatible with FAZER On-Road Series and FAZER Drift - Kyosho R246-8562  [KY-R246-8562]

Kyosho R246-8562 - RX 2 Way Connector
Price:
NZD$11.36
Brand:
Kyosho
Model:
KY-R246-8562
GTIN:
4548565203048
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $8.40 each $5.93 or 26%
3+ $7.56 each $11.41 or 33%
Write a review

Two-way receiver link for FAZER models

The Kyosho R246-8562 RX 2 Way Connector provides a tidy receiver wiring solution tailored to FAZER On-Road Series and FAZER Drift cars. It acts as a small junction that organises both signal and power leads without changing any onboard electronics or chassis components.

To fit, align the connector with the receiver leads, push the plug fully home, and route cables neatly to the chassis. Use cable ties to secure excess wire and prevent chafing during driving. This item is intended solely for scale electric RC vehicle wiring systems.

For maintenance the R246-8562 helps lower strain on connector joints and keeps wiring orderly, which can reduce intermittent connections when adjusting servo or ESC placement. It will not affect the voltage or performance characteristics of connected electronics.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this suitable for long-term running on FAZER drift setups?

Yes. The connector is built for regular use in FAZER On-Road and Drift models; secure wiring to limit stress and keep contacts clean for longevity.

Can it help prevent wire fatigue where servos move often?

By organising leads and allowing strain relief with ties, the junction reduces repetitive bending at servo and receiver joints that can cause fatigue.

Recommended practices for cleaning contacts?

Inspect contacts periodically and remove dust or residue with a dry brush; avoid solvents that may degrade plastic housings.

Will using this connector affect telemetry or signal quality?

No, it is a passive junction and will not alter signal integrity when connections are correct and contacts are clean.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved