This shaft set replaces the internal shaft of the LAW88 one-way slipper clutch and is marked ZX7.5 to match the original assembly. It installs into the existing LAW88 clutch housing without requiring other clutch component changes.
In service the shaft carries torque through the slipper and is part of how the assembly absorbs sudden load spikes. Installing a fresh shaft reduces variability from wear and helps keep clutch engagement points consistent between runs.
Installation notes: press the shaft into the LAW88 slipper housing ensuring the one-way orientation is correct. After assembly check that the mechanism rotates freely and adjust slipper preload and friction as required to preserve the desired engagement characteristics.
Replace the shaft when wear appears or when you need consistent slipper feel for setup testing and competitive RC driving.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
