Replacement Steering Servo for KC10 Chassis Kyosho 82283  [KY-82283]

Kyosho 82283 - Servo KS60111-15M
Price:
NZD$0.00
Brand:
Kyosho
Model:
KY-82283
GTIN:
4548565513369
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Kyosho - KC10 Chassis category
Write a review

Spare steering unit for KC10 fitment

This Kyosho spare is intended as a straightforward replacement steering servo for the KC10 chassis, supplied to maintain steering function on scale RC models while keeping setup simple. The focus is on correct fit and role rather than extracting performance figures.

Compatibility: designed to work as a spare across KC10 series installations; verify that mounting bracket locations and connector orientation align with your KC10 servo bay before proceeding.

Installation notes: when removing the old servo, note the horn orientation and linkage geometry. Mount the replacement in the same screw positions, centre the servo using your transmitter, then refit the linkage and check range and direction.

Tuning role: as a replacement component the servo returns steering control and enables routine re-calibration of endpoints and neutral, supporting consistent handling adjustments for the KC10 platform.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this servo suit every KC10 model?

The part is intended as a KC10 spare. Confirm that the screw positions and plug type on this servo match your KC10 variant before fitting to avoid alignment issues.

Any fitting advice for a clean swap?

Record the current horn position, centre the new servo from your transmitter, mount it using the original screws, then reconnect the linkages and perform a controlled steering check to confirm operation.

Will I need to recalibrate afterwards?

Typically you will only need to centre and set endpoints. Power up the radio, centre the wheel, and adjust endpoints and trims to restore the steering characteristics you had before.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved