This right-side front upper suspension arm is supplied in blue as a replacement component for Traxxas Revo chassis where the factory arm requires repair or a different finish is desired. It lines up with the Revo front mounting points for a clean swap on hobby or racing machines.
Installation notes: inspect pivot points and fasteners for wear, fit the arm in the correct orientation for the right side and ensure steering linkages and suspension travel are unobstructed. Run a short operational check to confirm steering centring and suspension movement.
Setup impact: the upper arm helps set camber response and roll centre. Installing an identical arm keeps stock geometry; any change in length or mounting offset should be treated as a tuning modification and rechecked during setup.
Verify clearance and movement after fitting and carry spare arms for quick replacements at events.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved