ROCHE 210209 Rapide P10 WGTR Aluminum Servo Mount - Precision Fit  [RH-210209]

RH-210209 Rapide P10 WGTR Aluminum Servo Mount C10258
Price:
NZD$20.65
Brand:
ROCHE
Model:
RH-210209
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Engineered Aluminum Servo Mount for Rapide P10 WGTR

Specifically made for the Rapide P10 WGTR platform, the ROCHE 210209 aluminium servo mount gives a direct, rigid connection between servo and chassis. The machined alloy resists wear and helps keep steering inputs accurate over repeated runs.

Strength That Helps Steering Response

The aluminium design reduces movement around the servo area, so steering feedback stays sharp when attacking corners. The mount is lightweight yet robust enough for regular track use.

Quick Swap Installation

Mounting the ROCHE 210209 is a straightforward job that matches the Rapide P10 WGTR factory fixing points. The fitment is precise, letting you change over without cutting or modification in most cases.

Can I use this mount with aftermarket servo arms?

Yes, aftermarket servo arms fit as long as the servo spline and arm clearance match; verify arm geometry to avoid interference with the chassis.

Will this part change my car's balance?

The mount adds minimal mass near the servo. Any balance change is usually negligible, but check trim and weight distribution after fitting if you run precise setups.

Is the ROCHE 210209 corrosion resistant?

The aluminium itself resists rust, but rinsing salt and grit after seaside tracks will prolong finish and mounting hardware life.

Any tips for avoiding servo slop after upgrade?

Use correct length screws, firm mounting points, and check servo spline engagement. Pairing the mount with a high-quality servo and tight linkages reduces slop.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved