ROCHE RH-240251 Foam Bumper 1/10 Scale WGTR Fit  [RH-240251]

RH-240251 Urethane Foam Bumper for 1/10 C40217
Price:
NZD$10.40
Brand:
ROCHE
Model:
RH-240251
Condition:
Brand New
Write a review

Built to Absorb Impact Energy

The ROCHE RH-240251 urethane foam bumper is intended to protect 1/10 scale models, with a close fit for Rapide P10 WGTR chassis. The foam shape spreads collision forces to lower the chance of damage to nearby parts.

Why Urethane Works Well

Urethane has a resilient feel that dampens shocks on contact, helping to preserve fragile components. It is a practical choice for hobbyists who do practice runs or prepare for local events.

Quick Installation Notes

Fitting this bumper is straightforward and it lines up with the Rapide P10 WGTR mounting points. No complex mods are usually required, though a quick check of mounting screws is recommended after first use.

Is the RH-240251 hard to install on a Rapide P10 WGTR?

Installation is generally simple for anyone familiar with basic RC maintenance. Align the bumper to the mounting points and secure with the standard screws supplied on the chassis.

Can I use aftermarket body mounts with this bumper?

Some aftermarket mounts may need slight trimming or repositioning to clear the bumper. Check fitment before final assembly and trial-fit the body over the installed bumper.

Will the bumper change handling or balance?

The bumper adds minimal weight up front and normally does not noticeably alter handling. If you focus on fine balance tuning, account for the small weight change when setting trim.

How do I care for the foam after hard hits?

After heavy impacts, clean debris from the surface and check for permanent deformation. Replace the bumper if the foam loses its rebound or develops deep cuts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved