ROCHE 210123 Rapide F1 EVO 7075 Aluminum Lower Pod Plate C10133 - Track Edition  [RH-210123]

ROCHE 210123 Rapide F1 EVO 7075 Aluminum Lower Pod Plate (2.5mm) C10133
Price:
NZD$23.26
Brand:
ROCHE
Model:
RH-210123
Condition:
Brand New
Write a review

Solid Chassis Support from ROCHE 210123

The ROCHE 210123 Rapide F1 EVO 7075 Aluminum Lower Pod Plate provides targeted reinforcement for racers wanting consistent lap times. Crafted from 7075 aluminum at 2.5mm thickness, this plate strengthens the lower pod area while preserving a lightweight feel on the Rapide F1 EVO.

Why Use 7075 Aluminum for the Lower Pod

7075 is chosen for its high tensile strength relative to weight, giving the pod plate the durability needed during hard cornering. The part is shaped to align with Rapide F1 EVO mounting points for a straightforward fit.

Quick Installation Notes

Designed for the Rapide F1 EVO series, the plate installs using the standard hardware layout and helps maintain pod stability under race loads. Confirm alignment and tighten fasteners evenly to avoid stress points.

Can I use this on converted chassis?

You can use it on modified chassis if mounting hole spacing and clearances match the Rapide F1 EVO layout; some trimming or additional brackets may be needed.

Does the plate change ride height?

The plate itself is thin and should not noticeably alter ride height, but combined with different mounting hardware it can have a small effect, so double-check setup after fitting.

Is additional reinforcement required for durability?

For most club and regional racing, the 7075 plate is sufficient. For extreme off-track use, inspect for impact damage and consider supplementary braces if needed.

What fasteners should I use?

Use the original Rapide F1 EVO mounting hardware or high-quality M screws of the same thread and length to ensure a secure fit without over-tightening.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved