ROCHE 220141 Rapide P10W EVO Lightweight Graphite Plate  [RH-220141]

ROCHE 220141 Rapide P10W EVO Graphite Servo Plate
Price:
NZD$15.54
Brand:
ROCHE
Model:
RH-220141
Condition:
Brand New
Write a review

Fine-Tune Your Rapide P10W EVO Handling

The ROCHE 220141 Rapide P10W EVO Graphite Servo Plate gives model builders a refined mounting option that trims weight and raises structural stiffness. Tailored for the Rapide P10W EVO, it helps maintain clean servo action and reduces unwanted movement under load.

Improved Feedback and Balance

Graphite construction provides a strong yet light base for your servo, improving the balance of your model and delivering more precise steering feel. This is particularly useful for drivers refining trim and steering response.

Quick Installation for Hobbyists

Designed as a direct replacement for the factory plate, the ROCHE 220141 fits the Rapide P10W EVO without machining. The straightforward install process gets you back to tuning and running faster.

Can I use this with a tall servo horn?

Yes, but verify clearance between the horn and any nearby chassis parts. The ROCHE 220141 keeps servo height similar to stock, so most common horns will fit.

Is the graphite finish fragile to handling?

Graphite is strong yet can chip if dropped. Handle with care during installation and avoid overtightening screws to preserve the edges.

Will this affect receiver placement?

No, the plate does not change receiver space. Keep radio gear mounted according to your chassis layout for tidy wiring and good signal reception.

Should I re-tune my servo end points after fitting?

It is good practice to check and fine-tune end points and centring after any mechanical change to ensure optimal steering travel and trim.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved