ROCHE 310066 Aluminum Ballstud 4.3x11.8mm Lightweight Reinforced S10084  [RH-310066]

ROCHE 310066 Aluminum 4.3x11.8mm Ballstud, Reinforced S10084
Price:
NZD$17.23
Brand:
ROCHE
Model:
RH-310066
Condition:
Brand New
Write a review

Precision Suspension Upgrade: ROCHE 310066

The ROCHE 310066 Aluminum 4.3x11.8mm ballstud is aimed at model builders who want a dependable joint that reduces flex. Constructed from aluminium, the part balances weight savings with improved toughness for everyday track use.

Precision Engineered for Stability

With its 4.3x11.8mm dimensions, ROCHE 310066 fits many linkages and ball cups, giving a more precise steering feel. The reinforced section resists deformation under repeated load so handling stays consistent.

Mounting and Common Uses

This ballstud works well when upgrading worn steering or suspension pivots and can be used across a broad selection of RC car platforms. It is a simple swap that can improve feedback during cornering and braking.

Do I need special tools to fit this ballstud?

No special tools are required beyond basic pliers or a driver for your model. Start the stud by hand and finish to the correct torque to prevent damage.

Is aluminium prone to wear compared with steel?

Aluminium is lighter and resists corrosion, though it can show wear faster than hardened steel in extreme use. The reinforced design of the ROCHE 310066 helps offset that by increasing strength where it matters.

Should I use threadlocker when installing?

Apply a low strength threadlocker for regular hobby use to keep the stud secure under vibration. For competitive setups, check service intervals and reapply as part of routine maintenance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved