ROCHE 310077 Precision 6mm Pivot Balls  [RH-310077]

ROCHE 310077 6mm Pivot Ball Set, Front Suspension
Price:
NZD$20.68
Brand:
ROCHE
Model:
RH-310077
Condition:
Brand New
Write a review

Better Front End Control with ROCHE 310077

The ROCHE 310077 6mm Pivot Ball Set is a straightforward replacement part for drivers aiming to restore crisp steering feel. It provides stable joint support that helps the front suspension react cleanly to inputs.

Where It Works Best

Designed around 1/10 scale norms, the 6mm pivot balls in the ROCHE 310077 set match many common front suspension geometries. This makes them handy for multi-car racers and club mechanics who swap parts between rigs.

Tips for Smooth Installation

Clean the connection points thoroughly before fitting the ROCHE 310077 Pivot Ball Set and inspect linkages for wear. Use a light coating of RC-grade lubricant to reduce noise and keep movement consistent.

Can I use ROCHE 310077 on off-road buggies?

While primarily sized for 1/10 scale front suspension, some off-road buggies with compatible ball cups can accept 6mm pivot balls. Verify cup clearance and suspension travel first.

Do these pivot balls need bed-in time?

After installation, run the car at low speed to allow components to seat. This initial break-in helps mating surfaces settle and improves long term smoothness.

Are special tools required to fit ROCHE 310077?

Basic RC toolsets are usually enough: hex drivers, pliers and a pick to remove old balls. For stubborn cups, a dedicated ball press can make the job easier.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved