ROCHE 310131 S10166 1.25mm Ride Height Shim Pack  [RH-310131]

ROCHE 310131 Aluminum Height Adjust Spacer, 1.25mm S10166
Price:
NZD$4.33
Brand:
ROCHE
Model:
RH-310131
Condition:
Brand New
Write a review

Fine shimming with ROCHE 310131

The ROCHE 310131 Aluminum Height Adjust Spacer 1.25mm is a compact tuning part that helps you refine ride height with confidence. By inserting these shims you can better control clearance and chassis attitude for different track types.

Compatibility with common 1/10 models

These aluminium spacers work well with many 1/10 scale models and are useful for both on-road and light off-road setups. Adjusting stack height can aid traction or reduce chassis tuck depending on your setup goals.

Practical installation pointers

Installation is straightforward: stabilise the car, remove the wheel, and place the spacer where needed in the suspension assembly. Reassemble and perform short test runs to confirm the change before making further tweaks.

Are these shims good for mixed surface tracks?

They can help tune clearance for mixed surfaces, but you should try small increments to avoid upsetting balance between front and rear.

What tools do I need to fit them?

Basic hand tools like a wheel nut driver and small spanner are enough; no special gear is required for simple spacer swaps.

How should I protect the spacers from corrosion?

Wipe clean after wet runs and consider a light corrosion inhibitor if you run in salty or wet conditions often.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved