ROCHE 310143 Rapide Pivot Brace Washer and Nut Workshop Pack  [RH-310143]

ROCHE 310143 Rapide Pivot Brace Washer & Nut
Price:
NZD$6.93
Brand:
ROCHE
Model:
RH-310143
Condition:
Brand New
Write a review

Stiffen Your Rig with ROCHE 310143

The ROCHE 310143 Rapide Pivot Brace Washer & Nut is a practical component for tightening pivot joins and improving overall stability. It helps limit looseness at pivot points so your setup stays truer to your tuning.

Practical Use Around the Workbench

From fine tuning to routine refreshes, this washer and nut set is useful when replacing tired hardware or upgrading stock fittings. It installs without special tools and slots into common pivot arrangements.

Compatibility Notes and Fastening Advice

This set suits a wide array of RC chassis styles, offering a flexible spare for club and backyard rigs. Fit carefully and check threads to ensure a secure, rattle-free connection.

Can I use ROCHE 310143 on vintage and modern cars?

Yes, it works with many older and newer pivot brace designs, but measure the thread and bore sizes to confirm compatibility before fitting.

Will this affect my handling balance?

By reducing play at the pivot, the part can sharpen steering response and consistency. Small changes are typical, so tune gradually and test between runs.

What tools are recommended for fitting?

A set of metric sockets or spanners plus pliers for holding the pivot is usually sufficient. Use moderate torque and avoid impact tools on the final tightening.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved