ROCHE 310157 Rapide Aluminum Long Shock Ball S10191 Track Ready Component  [RH-310157]

ROCHE 310157 Rapide Aluminum Shock Ball, Long S10191
Price:
NZD$10.34
Brand:
ROCHE
Model:
RH-310157
Condition:
Brand New
Write a review

Improve Handling with ROCHE 310157 S10191

The ROCHE 310157 Rapide Aluminum Shock Ball S10191 helps drivers refine damping response and cornering balance. Its long form factor is ideal when you need extra travel or finer geometry tweaks.

Where It Works Best

Designed to suit a variety of touring cars and off-road rigs that accept extended ball ends, this aluminum unit gives a predictable feel and stands up to repeated use on club tracks and informal circuits.

Fitting Notes

When fitting the ROCHE 310157 check that clearance is sufficient through the full suspension travel. Tighten securely but avoid over-torquing to prevent thread damage.

Will this work with foam inserts and big bore shocks?

Yes, the ROCHE 310157 S10191 is compatible with big bore setups as long as the shock eyelet and ball sizes match; it pairs well with stiffer insert setups.

Should I replace stock plastic balls with this part?

Upgrading from plastic can reduce flex and improve consistency, especially under load, but verify fit dimensions before swapping.

Does the long length affect spring preload?

A longer ball end can change effective leverage on the shock; check ride height and damper settings after fitting and adjust preload as needed.

What tools are best for installation?

Use a good quality hex driver or small spanner for the shock eye and a thread locker if your setup benefits from it; avoid excessive force on small screws.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved