ROCHE 310182 Rapide P12 EVO Aluminum Front Upper Bulkhead - Lightweight Steering Part  [RH-310182]

ROCHE 310182 Rapide P12 EVO Aluminum Front Upper Bulkhead
Price:
NZD$20.80
Brand:
ROCHE
Model:
RH-310182
Condition:
Brand New
Write a review

Precision Front Bulkhead by ROCHE

The ROCHE 310182 Rapide P12 EVO Aluminum Front Upper Bulkhead is made for model racers who want tighter steering control. Its aluminium construction gives resilience where the chassis needs it while keeping weight to a minimum for nimble handling.

Balanced Strength for Racing

Crafted from high-grade aluminum, this bulkhead resists wear from hard running yet remains light enough to avoid harming overall balance. That makes it useful for drivers chasing consistent lap times.

Designed for Direct Replacement

This component is specifically tailored for the Rapide P12 EVO chassis and installs cleanly with factory mounting points. No bodywork or chassis trimming is normally needed when following the standard install steps.

Can I use this bulkhead on other Rapide versions?

It is manufactured for the Rapide P12 EVO. Some older or newer Rapide variants may differ in mounting points, so verify dimensions before assuming compatibility.

Is this bulkhead heavier than stock plastic parts?

While metal is denser than plastic, the ROCHE 310182 is machined to minimise excess mass, offering a favourable strength-to-weight ratio compared with common plastic replacements.

Any tips for installation alignment?

Hand-start screws to avoid cross-threading and tighten in a criss-cross pattern to ensure even seating. Check steering geometry after fitting.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved