ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm) - Lightweight Race Upgrade  [RH-310192]

ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm)
Price:
NZD$38.13
Brand:
ROCHE
Model:
RH-310192
Condition:
Brand New
Write a review

Sharper Steering for Fine Adjustments

RC drivers who want a more precise front end can fit the ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm) to reduce chassis flex and sharpen turn-in. This upgrade targets better control without adding excessive weight.

Extra 1mm Tuning

The additional 1mm setting lets you dial in alignment more accurately, helping to stabilise the car through corner entry. The aluminium build offers a stiff, predictable mounting point for the front suspension.

Simple Fitment Process

Designed to slot into existing Rapide P12 EVO configurations, the bulkhead installs with routine RC maintenance steps and standard tools. It is compatible with common front-end setups used by club racers.

Is this bulkhead a direct replacement for the standard part?

For Rapide P12 EVO cars this is generally a direct swap, using the same mounting points. Check your current hardware to confirm screw lengths and spacers match.

Will it add noticeable weight to the front?

Aluminium brings a modest weight increase versus plastic, but the gain in stiffness and steering precision usually outweighs the small mass change for tuned setups.

Any setup tips after fitting?

After fitting, recheck toe and caster and run a few short tests. Small adjustments to anti-roll balance or toe-in can help extract the best handling from the new bulkhead.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved