ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A) 3/6 Degree S20182 - Track Tuner  [RH-320148]

ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A), (3/6 deg) S20182
Price:
NZD$10.34
Brand:
ROCHE
Model:
RH-320148
Condition:
Brand New
Write a review

Improve Cornering on the Rapide F1 EVO

Hobbyists wanting sharper steering can use the ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A) to adjust front geometry. The plate gives a selectable 3-6 degree front arm angle so you can experiment with handling across different surfaces.

Why Graphite Suits RC Setup

Graphite delivers a lightweight feel while keeping essential rigidity, which helps maintain quick steering response without adding weight. Its properties make it a sensible choice for drivers trimming grams and stiffness for track performance.

Quick Fit and Practical Adjustments

The mount plate fits the Rapide F1 EVO chassis with minimal fuss and is intended for rapid changes between runs. Use it to switch focus from tighter cornering to a more planted high-speed setup depending on the circuit.

Will this plate change ride height?

The plate alters arm angle rather than ride height; any ride height shift is minimal but should be checked after fitting to maintain intended geometry.

What surfaces benefit most from the adjustment?

Tight street-style tracks and technical layouts benefit from increased steering response, while smoother high-speed tracks may favour lower angle settings for stability.

Do I need special tools to swap angles?

Basic hex drivers and a torque check are all you need to swap the plate settings; no advanced tools are required for normal adjustments.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved