ROCHE 330106 P12 2mm Titanium Upper Hinge Pin Set 2 Pack S30137  [RH-330106]

ROCHE 330106 P12 2mm Upper Hinge Pin, Titanium Coated, 2 pcs S30137
Price:
NZD$10.40
Brand:
ROCHE
Model:
RH-330106
Condition:
Brand New
Write a review

Robust titanium upper hinge pins for RC suspension

The ROCHE 330106 P12 2mm Upper Hinge Pin offers a dependable option for model makers wanting stronger suspension pivot points. The titanium finish improves surface wear characteristics during frequent running.

Typical installation and compatibility

Designed for suspension setups that take a 2mm pin, these upper hinge pins fit into common hubs and mounts to maintain alignment and reduce slop through extended use.

Benefits of the titanium finish

Titanium coating gives these pins improved resistance to rust and surface damage, which is useful when you run on grass, gravel or other outdoor venues.

Will these pins suit vintage and modern models?

They suit any model that specifies a 2mm upper hinge pin, but check the required pin length and chassis layout on older kits.

Should I lubricate ROCHE 330106 P12 pins before use?

A light coating of grease or oil at the contact points can reduce wear and keep movement smooth, especially after running in wet or sandy conditions.

Do these pins need special tools to fit?

No special tools are required; normal pliers and pin drivers used for 2mm pins are sufficient for installation and removal.

How do I check for pin wear?

Inspect for scoring, straightness, and looseness in the hub. Replace if you notice wobble or visible damage to the surface coating.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved