ROCHE 330108 Precision Titanium Shock Shaft - Rapide P10W EVO2  [RH-330108]

ROCHE 330108 Rapide Micro Shock Shaft, Titanium Coated (S30139)
Price:
NZD$7.75
Brand:
ROCHE
Model:
RH-330108
Condition:
Brand New
Write a review

Precision Shaft with Titanium Finish from ROCHE

The ROCHE 330108 Rapide Micro Shock Shaft brings a tougher surface finish to your shock stack, helping the suspension run cleaner and with less stiction. Its titanium coating is chosen to resist scuffing and keep the damper moving freely during extended club sessions.

Reduced Friction for Cleaner Response

A low-friction titanium layer reduces bind at the seal interface so your shocks respond more predictably. That steadier motion helps drivers dial in rebound and compression with greater confidence on mixed surfaces.

Engineered for Rapide P10W EVO2 Chassis

Specifically sized for the Rapide P10W EVO2, the shaft integrates with the original damper parts and mounting. The accurate fit preserves alignment and allows racers to keep their current spring and oil choices.

Will the ROCHE 330108 fit my existing Rapide shocks?

If your Rapide uses the stock Rapide P10W EVO2 damper dimensions, the ROCHE 330108 will match. Verify shaft length and diameter before installation to avoid surprises.

Is the titanium layer corrosion resistant?

The coating increases surface hardness and helps resist wear rather than acting as a full corrosion barrier. Keep parts clean and dry after wet runs to protect the shaft long term.

Does this change shock tuning?

The shaft itself does not alter spring rates, but reduced friction can make damping feel more consistent, so small oil or shim adjustments may be useful after fitting.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved