ROCHE 340073 Steering Knuckles Replacement Set  [RH-340073]

ROCHE 340073 Steering Knuckle Set
Price:
NZD$9.48
Brand:
ROCHE
Model:
RH-340073
Condition:
Brand New
Write a review

Compact ROCHE 340073 Steering Knuckles for Everyday Running

The ROCHE 340073 Steering Knuckle Set gives modelers a practical way to replace worn steering components. It is intended for those who routinely maintain their rigs and need dependable steering geometry.

Model Compatibility

These knuckles were designed with common 1/10 scale mounting patterns in mind, allowing fitment across a variety of touring cars and buggies. They help keep steering predictable when swapping setups.

Simple Installation Notes

Install the knuckles with correct hardware alignment and tighten fasteners evenly to avoid distortion. Regular checks of ball joints and tie rods will catch issues before they impact handling.

Can I use ROCHE 340073 on my drift car?

You can use these knuckles on many 1/10 drift setups, but verify steering arm orientation and camber link locations to ensure proper fit and steering geometry.

Are replacement bearings required?

The knuckles work with standard bearing sizes used in most 1/10 builds, though some installs may benefit from fresh bearings if the old ones show wear.

Do these parts affect steering feel?

Stiff, well-fitted knuckles reduce unwanted slop and can make steering feel sharper, especially after replacing worn or damaged stock parts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved