ROCHE 340144 Center Pivot Brace - On-Road Tuning Component  [RH-340144]

ROCHE 340144 Center Pivot Brace
Price:
NZD$6.86
Brand:
ROCHE
Model:
RH-340144
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-Tune Chassis Behaviour with ROCHE 340144

The ROCHE 340144 Center Pivot Brace stiffens the middle of the chassis to cut unwanted movement and refine how the car balances through corners. It is a compact upgrade for builders who like to dial in handling without big changes.

Where It Works Best

Compatible with many 1/10 scale on-road setups, the brace helps maintain chassis geometry under load and keeps suspension action more consistent during tight sequences.

Installation Hints

When fitting the ROCHE 340144 Center Pivot Brace align it carefully with existing mounts and use firm, even torque on all fasteners; check alignment after the first few runs to confirm settings.

Can this be used on modified touring cars?

Yes, it can fit modified touring cars provided the chassis has the relevant mounting points and no conflicting components in the centre section.

Does it affect tyre wear?

It can alter load distribution slightly, which may change wear patterns; monitor tyres after fitting and adjust camber or toe if needed.

Do I need new screws to fit it?

Often you can use the existing hardware but using fresh stainless or alloy screws improves reliability and prevents seized threads.

How should I test setup changes?

Run a few measured laps, note understeer or oversteer shifts, then tweak brace position or suspension settings to find the best balance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved