ROCHE 530020 King Pin Shim Pack M3.2x0.4 10 pcs S30019 Track Tuner  [RH-530020]

ROCHE 530020 King Pin Shim, M3.2x0.4, 10 pcs S30019
Price:
NZD$4.31
Brand:
ROCHE
Model:
RH-530020
Condition:
Brand New
Write a review

Fine suspension tweaks using ROCHE 530020 shims

RC tuners can use the ROCHE 530020 King Pin Shim set to make careful changes to suspension geometry. These M3.2x0.4 shim washers are intended for small adjustments that improve steering precision and consistency on different surfaces.

Benefits of precise shim adjustments

Using thin shims lets you modify camber and caster without major component swaps. That nuanced control can reduce tyre scrub and give better balance through corners when dialled in properly.

Compatibility and typical uses

The shims fit a wide selection of 1/10 scale models, making them handy for both indoor carpet racing and rougher outdoor tracks. Keep several thicknesses on hand to experiment with setup changes between runs.

Can I use ROCHE 530020 shims on any 1/10 model?

They are compatible with many 1/10 scale setups, though you should check king pin diameter and hub spacing before fitting. Minor variations between brands may require simple tweaks.

How many shims should I add per side?

Start with a single shim per side and test handling. Add or remove one at a time while noting changes so you can find the right balance for your driving style and surface.

Will these shims affect suspension travel?

Thin shims generally have minimal impact on overall travel, but they change pivot geometry enough to affect weight transfer and corner behaviour. Observe results and adjust accordingly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved