ROCHE 530038 4mm Flanged Nut H10046 - Compact Steel Fixing  [RH-530038]

Price:
NZD$4.29
Brand:
ROCHE
Model:
RH-530038
Condition:
Brand New
Write a review

Dependable ROCHE 530038 4mm Flanged Nut

The ROCHE 530038 4mm flanged nut provides a low-profile, sturdy fastening solution for RC components. Constructed from steel, it resists deformation and helps keep threaded joints secure under load.

Where It Fits Best

Use this flanged nut on steering linkages, body posts and small chassis fittings where a broad seating area improves stability. Its size and strength make it a useful spare for a range of electric and nitro models.

Quick Installation Tips

Hand-start the nut onto the bolt to avoid cross-threading, then tighten with the correct tool for even pressure. If you often run on rough surfaces, check the joint periodically and retighten as needed.

Will the ROCHE 530038 fit aluminium bolts?

Yes, the nut will thread onto standard 4mm aluminium or steel bolts with matching pitch. Be cautious tightening aluminium bolts to avoid gullying the threads.

Is rust a concern for this steel nut?

Plain steel can show surface corrosion over time in wet conditions. For long-term protection consider light oiling or using stainless options where exposure is frequent.

Can I reuse these nuts after removal?

You can reuse them provided threads are undamaged and the flange seats cleanly. Replace any nut that shows thread wear or flange distortion to maintain secure joints.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved