ROCHE 610002 Flanged Bearings 3/8 x 1/4 Pair B10002  [RH-610002]

ROCHE 610002 Bearing, 3/8 x 1/4, Flanged, 2 pcs B10002
Price:
NZD$6.03
Brand:
ROCHE
Model:
RH-610002
Condition:
Brand New
Write a review

ROCHE 610002 Flanged Bearings for Accurate Rotation

The ROCHE 610002 flanged bearings deliver consistent rolling accuracy for RC builds where tight tolerances matter. Sized at 3/8 x 1/4 inches, they are suitable for small shafts and hub assemblies that need reliable support.

Consistent Low-Friction Performance

Designed to keep rotating parts turning with minimal drag, these flanged bearings reduce heat and wear in gear trains and axle assemblies. They are practical for hobbyists who run varied sessions, from casual practice to club meets.

Broad Use Across RC Builds

The ROCHE 610002 bearings work well in many RC layouts, from touring cars to light off-road models. Use them as a simple upgrade or as replacements during routine maintenance to keep drivetrains running true.

Will these bearings fit standard wheel hubs?

Often yes, they match many common hub inner diameters; measure the hub bore and shaft before ordering to confirm a correct fit.

Can I use them in gearbox assemblies?

These bearings can be used in light gearbox applications where the load is moderate. For high torque gearboxes check bearing load ratings and consider upgraded types if needed.

How do I keep them clean?

Wipe away grit and old lubricant, then apply a small amount of fresh grease. Avoid using solvents that remove all lubrication on long-running parts.

Are these bearings pre-lubricated?

Some batches come lightly greased from the factory but a quick inspection and re-lube for your application is recommended for best results.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved