ROCHE 610010 Bearing 5x10x4mm B10010 Compact RC Replacement  [RH-610010]

ROCHE 610010 Bearing 5x10x4mm B10010
Price:
NZD$4.36
Brand:
ROCHE
Model:
RH-610010
Condition:
Brand New
Write a review

Compact Bearings for Radio Control Use

The ROCHE 610010 Bearing 5x10x4mm B10010 provides a neat, low-profile solution for rotating parts in models. Its small footprint helps maintain efficient motion in hubs, pulleys, and gearbox linkages without adding bulk.

Where It Works Best

This 5x10x4mm bearing is useful across a broad range of kit and RTR models, compatible with many chassis and component layouts where compact bearings are required. It is a common size for wheel and drivetrain service replacements.

Care and Installation Tips

Keep the bearing seat free of grime before fitting and press it in squarely for correct alignment. A drop of light oil after cleaning can keep the bearing turning freely and extend service intervals.

Will this bearing work for vintage RC models?

If the vintage model originally used a 5x10x4mm size, this ROCHE bearing will fit as a direct replacement, but always double check the shaft and housing tolerances.

How often should I service these bearings?

Service frequency depends on use; inspect bearings after wet or dusty runs and clean and relubricate as needed to avoid premature wear.

Are special tools needed to press this bearing in?

A simple bearing driver or a socket that matches the outer race will help seat the bearing evenly; avoid hammering on the inner race to prevent damage.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved