Rustler VXL Front #45 Hardened Steel CVD Axle SRUS41280FH by GPM  [SRUS41280FH]

Durable 1/10 front #45 axle for Rustler VXL

This front axle assembly is intended for TRAXXAS Rustler VXL 1/10 models to transmit drive forces and maintain front wheel geometry under use. The axle combines a hardened #45 steel shaft with a 6061 T6 aluminium alloy body to deliver torsional strength while keeping rotating mass lower for RC performance.

Design features include a CVD configuration to keep rotation consistent across steering throw, a retractable body section to boost ground clearance and articulation, and a spring steel hex insert for added stiffness where the wheel loads concentrate. These are RC-scale features rather than full-size vehicle parts.

The kit includes the components needed for replacing the stock front axle subassembly as listed below:

• CVD - 2 pcs
• Screw Pin M4x2.5x12 - 2 pcs
• 4x2.5 Silicone O-Ring - 2 pcs
• 3x3 Screw Shaft - 2 pcs

Installation guidance: this axle is produced to interface with the stock mounting points and driveline on TRAXXAS 1/10 Rustler VXL variants. Verify CVD seating and spline fit, and apply proper lubrication during assembly. The unit serves as a direct upgrade or replacement for hobby RC drivetrains.

For tuners seeking a firmer front driveline on the Rustler VXL, this assembly combines hardened steel strength with an aluminium body and CVD geometry to improve front axle behaviour in scale RC use.