SAK-D6808D/RE ARS Linkage Mount for Auper D6 by 3Racing  [SAK-D6808D/RE]

ARS Link Mount Compatible with Auper D6

This precision aluminum ARS linkage mount is a direct replacement for the plastic bracket on Auper D6 chassis, using the same linkage attachment points. The red anodized finish delivers a clean, machined mounting surface as an upgrade over the stock part.

Functionally, the mount gives additional ARS mounting positions so you can refine linkage geometry and on-track roll response without swapping major suspension components. The aluminum construction provides a firmer reference for link connections, helping to maintain alignment under load and enabling repeatable tuning sessions.

Installation is simple: remove the factory mount, drop the aluminum unit into the original location, and secure it with the existing hardware from your kit. After fitting, confirm link lengths and ball-end alignment at full droop and full bump to avoid binding or unwanted preload.

Notes: intended as an RC-scale spare for chassis setup and handling adjustments; best suited to hobbyists adjusting linkage settings on 1/10 touring cars that follow the Auper D6 mounting layout.