Designed as a replacement tail component for the SCEADU FZ-V platform, this RC stabilizer stopper limits travel and helps set both neutral and end positions in the tail linkage system.
The stopper functions as a repeatable mechanical stop inside the tail linkage area, aiding adjustments and routine maintenance. It is suited to model use only and is not intended for full-size aircraft applications.
Fitting is simple for those familiar with tail-case access: remove the tail cover, place the stopper at the stabilizer or linkage following your model's layout, and fasten using the existing mounting holes and screws. Minor position changes let you refine tail response and centring.
In tuning sessions the stopper is used to control travel limits during setup, avoid excessive servo travel on tail mechanisms, and provide a repeatable reference when trimming or programming end points.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
