Schumacher FT9 Graphite Front Hub Plate Aftermarket - Factory Pro O-SCP037  [FP-O-SCP037]

Price:
NZD$20.61
Brand:
Factory Pro
Model:
FP-O-SCP037
Condition:
Brand New
Write a review

Front hub plate for FT9 steering

This Factory Pro front steering hub plate is designed specifically for the Schumacher FT9 and is supplied as a single pair in graphite material. It is an RC-scale replacement intended to mount at the front steering knuckle to support linkages and maintain proper hub alignment on the FT9 chassis.

Graphite provides a balance of rigidity and lightness without implying extra speed; installers should replace the original front hub plate with this unit, ensure bearings sit true and hex screws are correctly tightened, and validate steering geometry before driving. It is compatible with standard FT9 steering parts and common servo arrangements.

Use this plate when replacing worn components or when adjusting steering characteristics, following normal RC workshop procedures and avoiding modifications that alter the factory mounting points.

Is this an OEM Schumacher part?

No, Factory Pro O-SCP037 is an aftermarket graphite replacement compatible with the Schumacher FT9; it is not manufactured by Schumacher.

How should I check alignment after fitting?

After installation, spin the wheel hubs by hand to check for bearing runout, confirm hex screw seating and verify the steering track and toe settings before running.

Can I use this with stronger servos?

Yes, the plate is compatible with standard FT9 servo setups; just ensure servo linkages and mounts match the FT9 geometry and avoid forcing different mounting points.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved