Schumacher FT9 Replacement Rear Lower Arm by Factory Pro O-SCP039R  [FP-O-SCP039R]

Price:
NZD$21.08
Brand:
Factory Pro
Model:
FP-O-SCP039R
Condition:
Brand New
Write a review

Replacement rear lower arm for FT9 chassis

The Factory Pro O-SCP039R rear lower suspension arm is an aftermarket component produced for the Schumacher FT9 touring car platform and supplied as one unit for direct swap-in replacement.

Overview: this part takes the place of the FT9 factory rear lower arm and secures to the original suspension points and fasteners. It is intended as an RC-scale replacement for scheduled maintenance, incident repairs, or quick setup revisions between sessions.

Installation and fitment notes: swapping the arm follows normal FT9 chassis procedures, using the existing mounting pins and fasteners on the rear hub and upright. No cutting or drilling of the chassis is necessary when fitted to a prepared FT9 rear end.

Tuning role: fitting the O-SCP039R helps recover correct suspension geometry and maintains predictable handling while you adjust toe, camber and roll behaviour in the FT9 rear suspension layout.

Will this arm mount to standard FT9 rear uprights?

Yes. It is machined to fit the standard FT9 rear upright and uses the same mounting hardware as the original arm.

Does the listing include hardware?

The arm is supplied as one piece only; reuse the existing pins and fasteners from your FT9 unless you choose to replace them separately.

Should I adjust setup after fitting this arm?

After fitting, check toe and camber and perform a short test to ensure handling is as expected, especially if the previous arm was worn or bent.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved