Schumacher Mi10 Front Lower Arm - Compatible Replacement O-SCP047F by Factory Pro  [FP-O-SCP047F]

Price:
NZD$19.08
Brand:
Factory Pro
Model:
FP-O-SCP047F
Condition:
Brand New
Write a review

Lower front arm for the Mi10 chassis

The Factory Pro lower suspension arm O-SCP047F is produced for the Schumacher Mi10 and supplied as a single front-side replacement item. This listing covers a direct-fit component intended to occupy the Mi10 front lower arm location without altering other chassis elements.

The description emphasises restoring correct suspension geometry: the arm functions as a like-for-like replacement for maintenance or tuning tasks. It is appropriate for routine RC inspection, confirming ball joint movement, and minor setup adjustments to influence front-end handling.

Installation note: install into the factory Mi10 lower-arm mounts and reuse the existing linkage points and hardware. After installation, inspect contact faces and suspension travel to confirm free movement and correct clearance.

How do I fit this to my Mi10?

Remove the original front lower arm, position the Factory Pro O-SCP047F in the factory mounts, and secure using the existing linkage hardware. Check that ball joints move freely after tightening.

Does the arm include mounting hardware?

The arm is supplied as a single replacement piece intended to use the Mi10's existing hardware and linkage points rather than bundled new fasteners.

Any recommended inspections post-fit?

After fitting, verify ball joint articulation and suspension travel and confirm there is no binding at full compression and droop.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved