Schumacher Mi10/Mi9/Mi8 HGT Upgrade Front Split Upper Deck Graphite 1.6 O-SCP043S by Factory Pro  [FP-O-SCP043S]

Price:
NZD$21.14
Brand:
Factory Pro
Model:
FP-O-SCP043S
Condition:
Brand New
Write a review

Overview of the front split upper deck for Schumacher Mi10 chassis

This front split upper deck is an aftermarket replacement crafted for the Schumacher Mi10 lineup. Manufactured in graphite 1.6, it focuses on tuning front chassis stiffness and balancing steering feel while leaving powertrain and electronics unchanged.

Fitment and use: the deck mounts at the front shock tower area and is shaped to align with the factory mounting pattern used across Schumacher Mi10/Mi9/Mi8 HGT variants. Standard installation follows the original screw locations and normally uses stock hardware.

Tuning notes: a graphite 1.6 plate will stiffen the front section, which can enhance initial turn response and modify mid-corner balance; plan to fine tune suspension and sway bar settings during setup runs.

Compatibility

  • Schumacher Mi10
  • Schumacher Mi9
  • Schumacher Mi8 HGT

Is this deck a true replacement for the original Schumacher upper deck?

Yes; it is produced to replicate the stock mounting interface for the listed Schumacher chassis so it acts as a direct replacement in typical builds.

What handling changes should I expect with graphite 1.6?

Graphite 1.6 raises front stiffness and will usually tighten turn-in while shifting balance through mid-corner. Use controlled test laps to assess how much suspension or roll bar tuning is required.

Any special tips for installing on Mi9 or Mi8 HGT variants?

Follow the chassis manual for torque and hardware guidance; generally the deck installs with the stock screws and common hex drivers are sufficient. Check clearance around the shock tower once fitted.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved