Factory Pro O-SCP020 Graphite Rear Tower - Schumacher Mi9  [FP-O-SCP020]

Price:
NZD$18.20
Brand:
Factory Pro
Model:
FP-O-SCP020
Condition:
Brand New
Write a review

Track-Focused Graphite Rear Tower for Schumacher Mi9

The Factory Pro O-SCP020 rear shock tower is crafted specifically for the Schumacher Mi9, using precision-cut graphite to cut mass while keeping chassis strength where racers need it. Its clean finish and exact dimensions help maintain consistent suspension behaviour across heats.

Why Graphite Is Favoured by Racers

Graphite offers a strong but light alternative to metal or composite parts, improving response without compromising durability. The Factory Pro O-SCP020 capitalises on those traits to reduce unwanted flex and deliver repeatable handling lap after lap.

Easy Swap and Correct Alignment

This rear tower lines up with the Schumacher Mi9 factory mounting layout for a straightforward replacement. Installation is quick using standard tools, making it a practical upgrade between meetings or during a setup session.

Can I use my existing screws and spacers?

In most cases the original mounting hardware will work. Check for any wear and replace stripped screws to avoid stress points in the graphite.

Will this improve rear traction?

By stiffening rear support, the tower can make suspension reactions more consistent, which often helps fine-tune traction. Traction gains depend on overall setup and track conditions.

Is graphite prone to chipping on impact?

Graphite is strong but can crack under heavy impact. Use protective bumpers and avoid overtightening fasteners to reduce risk of damage.

Any setup tips after installing this tower?

After fitting, check droop and roll centre, and try slightly softer rear springs if the car feels too lively. Small changes often yield the best balance improvements.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved