Schumacher Mi9 Factory Pro O-SCP024R Graphite Steering Hub Plate  [FP-O-SCP024R]

Price:
NZD$15.37
Brand:
Factory Pro
Model:
FP-O-SCP024R
Condition:
Brand New
Write a review

Schumacher Mi9 Upgrade with Factory Pro O-SCP024R

Refresh the steering feel of your Schumacher Mi9 using the Factory Pro O-SCP024R graphite steering hub plate. The dense graphite material increases stiffness where it matters, helping drivers get cleaner turn-in and steadier mid-corner behavior.

Designed to Reduce Flex and Improve Feel

The Factory Pro O-SCP024R is engineered to cut unwanted flex while keeping mass low, so steering inputs are transmitted more directly. Its robust graphite makeup helps preserve geometry through repeated use and aggressive driving.

Direct Fitment and Quick Swap Installation

Specifically produced for the Schumacher Mi9 chassis, this hub plate installs with minimal fuss and works with the stock steering layout. It is a straightforward swap for racers looking to tweak front-end balance without major teardown.

Can I use this on a modified Mi9 with different bulkheads?

If bulkheads or mounting points have been altered you should verify hole alignment. Small shims or alternate bolts can help, but major chassis changes may prevent a clean fit.

Will graphite affect steering speed or feel?

Graphite reduces flex compared to softer materials, so steering tends to feel sharper and more immediate. Expect firmer feedback particularly on quick direction changes.

Is any special preparation needed before fitting?

Clean mating surfaces and inspect the plate for shipping marks. Lightly sand any burrs on bolt holes and use appropriate torque on fasteners to avoid over-stressing the graphite.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved