Factory Pro FP-O-SCP038R Schumacher FT9 Rear Steering Hub Plate Graphite  [FP-O-SCP038R]

Price:
NZD$15.16
Brand:
Factory Pro
Model:
FP-O-SCP038R
Condition:
Brand New
Write a review

Graphite Rear Hub Plate by Factory Pro for Schumacher FT9

Owners of the Schumacher FT9 can fit the Factory Pro FP-O-SCP038R as a rugged spare to tidy up steering response. Built from quality graphite, this hub plate aims to keep your front end responsive during close racing.

Why Graphite Works Well

The material gives a good ratio of stiffness to mass, helping the steering components resist flex while keeping overall weight down. That balance supports tight, repeatable steering inputs on varied surfaces.

Compatibility Notes and Installation Tips

Specifically produced for the Schumacher FT9, the Factory Pro hub plate should align with existing mounting points. Install it with care and recheck steering geometry after fitting to ensure expected handling.

Is this part only for the FT9 chassis?

This hub plate is designed for the Schumacher FT9; other models may not share the same mounting pattern.

Does graphite need sealing or coating?

Standard graphite does not require sealing; just keep it clean and free from abrasive debris after runs.

Can I use the same screws from the original plate?

In most cases the original hardware fits, but inspect screws for wear and replace if damaged to maintain secure mounting.

Will this affect caster or toe settings?

The plate is a like-for-like replacement so major geometry changes are unlikely, though a setup check after installation is recommended.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved