Serpent 110475 Thin 4x8x0.3 Shim for RC Clearance Adjustment  [SER110475]

Thin spacer for precision setup

This component, Serpent SER110475, is stamped 4x8x0.3 and serves as a thin spacer washer for model assemblies. It is intended to make small positional changes where tight tolerances affect drivetrain alignment, steering links, or suspension pick-up points.

Such shims correct side-to-side play, define shaft endplay, and help establish repeatable stack heights during gearbox and linkage assembly. Because the item is specified by its dimension code, confirm that 4x8x0.3 is the correct size for your chassis location before fitting.

Fitting is simple: place the shim where clearance must be reduced and check motion after each placement. Shims may be layered for intermediate thicknesses, but always inspect component freeplay and bearing preload after any change.

Store shims flat to avoid distortion and segregate sizes to prevent accidental mix-ups during service. For exact model compatibility, review the vehicle's exploded parts diagram or replacement list rather than relying on appearance alone.