Serpent 402130 Carbon Rear Bodymount - Medius X25 Tuning Part  [SER402130]

Serpent SER402130 Bodymount carbon rr X25
Price:
NZD$39.42
Brand:
Serpent
Model:
SER402130
Condition:
Brand New
Write a review

Stiffen the Rear End for More Consistent Laps

The Serpent 402130 Carbon Rear Bodymount is built to reduce rear chassis flex on the Medius X25, helping drivers keep setups predictable through a stint. Constructed from durable carbon fiber, it balances strength with minimal added mass so acceleration and traction feel remain sharp. This component suits tuners focused on repeatable performance at club or regional events.

Specifications

  • Material: Carbon fiber composite
  • Compatibility: Serpent Medius X25

For hobbyists wanting a durable rear mount that supports consistent handling, this carbon upgrade is an efficient way to tighten up the Medius X25 chassis.

Does this require any chassis modification?

No permanent chassis modifications are needed. The part uses existing mounting points on the Medius X25, though you should check hole alignment before final torque.

Is carbon fiber noticeably lighter than the stock part?

Carbon offers a high strength-to-weight ratio. While weight savings may be modest, the main benefit is increased rigidity without a heavy penalty.

Any special maintenance tips?

Inspect mounting hardware regularly for loosening and check the carbon for chips after heavy impacts. Replace damaged mounts to keep handling consistent.

Will this fit with aftermarket body posts?

Most aftermarket posts that use the standard Serpent rear mounting pattern should work, but verify clearances and screw lengths to avoid interference.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved