Serpent 402190 X26 Steel Front Bumper for Medius X26  [SER402190]

Price:
NZD$195,341.15
Brand:
Serpent
Model:
SER402190
Condition:
Brand New
Write a review

Product summary and fitting notes

The Serpent 402190 Bumper X26 serves as a direct steel replacement for Serpent Medius X26 steel EP assemblies referenced under SER400052. It provides a stable mounting surface at the front of the chassis, helping to distribute impact forces and to maintain a repeatable bumper height reference.

Intended for hobbyist maintenance and setup procedures, this part prioritises consistent fitment and material durability over performance upgrades. Before installation, confirm that your chassis code matches the listed compatibility and examine existing fasteners for wear.

When installing: check that the new bumper's orientation matches the original, line up the holes with the chassis brackets, and ensure a flush fit to preserve the designed clearance and shock travel. Since mounting patterns can vary, reuse the original mounting pattern and hardware supplied with your kit where practical.

Specifications

  • Item: Bumper X26
  • Material: Steel
  • Model Number: SER402190
  • Compatibility: Medius X26 steel EP (SER400052)

The Serpent 402190 Bumper X26 is intended to restore the front mounting geometry on Medius X26 steel EP kits and to assist routine repairs and set-up checks on 1/10 scale RC touring car chassis.

How tough is the steel construction under repeated impacts?

Steel offers higher resistance to abrasion and deformation than many plastics, but repeated hard impacts can still cause bends or stress at mounting points, so inspect regularly after heavy use.

Will the steel bumper corrode over time?

Surface corrosion depends on finish and storage; if your bumper shows surface rust, remove it and treat or replace the part to prevent degradation that could affect fit.

Can I straighten a bent steel bumper?

Minor bends can sometimes be carefully corrected, but any deformation at the mounts that changes alignment should prompt replacement to ensure correct chassis geometry.

Does the bumper come with protective finish?

The listing indicates steel construction but does not detail finishes. If corrosion protection is a concern, consider applying an appropriate coating or using a protected storage method.

What signs indicate the bumper needs replacement?

Look for cracks, significant bends at mounting points, or any distortion that prevents a flush fit. Any change that alters bumper height or alignment warrants replacement.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved